Skip to main content

Discharges Tab Page

On this tab page the details of all operating sprinklers/nozzles, hydrants/standpipe or fixed discharges that are to be entered in the long hand form are entered.

The buttons on the Tool Bar for this page are:

imageebx_482209733.gif Close - exits this screen

imageebx_463499438.gif Show Errors

imageebx_668880439.gif Deletes the current line of Sprinkler/Nozzle or Fixed Discharge data

imageebx_1194395346.gif Add a sequential group of Sprinklers/Nozzles - does not apply to Discharges nor adding single sprinklers/nozzles. Note when display is All, single Sprinklers or Nozzles can be added by going to the last line which will be blank ready for input.

imageebx_-402274554.gif Help on the current tab page.

imageebx_2048742289.gif Display Sprinklers & Nozzles – All or Compressed

Sprinklers/Nozzles

The items that are entered for each sprinkler/nozzle are:

Node No. (when display is All) or

From Node No., To Node No. (when display is Compressed)

Type - Sprinkler or Nozzle

Elevation

Minimum Flow

k Factor

Pressure Exponent

Operating

Hydrants/Standpipes

The items that are entered for each hydrant/standpipe are:

Node No.

Elevation

Minimum Flow

Min. Pressure

Max. Pressure (optional)

Operating

Above the input data table for the sprinklers/nozzles and for the hydrants/standpipe are fields which allow the entry of defaults which apply to any sprinkler/nozzle or hydrant/standpipe where this field is blank: If no defaults are entered for any item (column) then all rows in that column must have values except the Pressure Exponent for Sprinklers/Nozzles and the Maximum Pressure for Hydrants/Standpipes as these are not mandatory fields.

Above the “Operating” column for Sprinklers and Nozzles Hydrants and Standpipes, there are two buttons to Clear All or Check All.

Above the Hydrants/Standpipes Table there are two radio buttons to control whether the flow for the Hydrants/Standpipes are to remain fixed or allowed to vary with pressure.

Fixed Discharges

imageebx_-1144421968.gif This brings the Fixed Discharge input data table on screen.

Fixed discharges are nodes that have a fixed discharge. When analyzing a hydrant system a fixed discharge can be used to model a fire hydrant that has a fixed flow regardless of the pressure at the connection point

The items that are entered for each fixed discharge are:

Node No.

Elevation

Discharge