Surf Roughness
The absolute roughness of the pipe for use in the friction factor formula when using the Darcy Weisbach method. Typical values are:
| Â | AS2118 | NFPA, SSCP52 & GB50084 | NZ4541 | |||
|---|---|---|---|---|---|---|
| Material | mm | Source | mm | Source | mm | Source |
| Cement Lined CI. | 0.045 | NFPA750 | 0.045 | NFPA750 | 0.045 | AS4587 |
| Unlined Cast Iron | 0.256 | ASHRAE | 0.256 | ASHRAE | 0.256 | ASHRAE |
| Copper | 0.0021 | AS4587 | 0.0021 | NFPA | 0.045 | NFPA750 |
| S SteelPipe | 0.045 | AS4587 | 0.045 | NFPA750 | 0.045 | NFPA750 |
| Steel | 0.102 | NFPA | 0.102 | NFPA | 0.102 | NFPA |
| PVC & CPCV | 0.0015 | AS4587 | 0.0021 | NFPA | 0.0015 | NFPA750 |
| HDPE | 0.0015 | AS4587 | 0.0021 | NFPA | 0.045 | NFPA750 |
| HOSR | 0.0015 | AS4587 | 0.0021 | NFPA | 0.045 | NFPA750 |
| HOSC | 0.256 | Unknown | 0.256 | Unknown | 0.256 | Unknown |
Values of Surface Roughness where Source is in italics are taken from a different pipe material with same HW in listed code .
For roughness coefficient used with AS4587 and NFPA750 see Surf Roughness - Mist Systems
The Surface Roughness is entered in a number of places:
- a default value may be entered above the Surf Roughness heading on the Pipes Tab Page and on the GRID Main Pipes Tab Page. Pipes with the Surface Roughness left blank in the column below these defaults will assume the default value.
- For an individual pipe in the Surface Roughness column on the Pipes Tab Page.
- For the individual main or rising main pipes in a GRID on the Main Pipes Tab Page.
- For the individual range or tree pipes in a GRID on the Ranges and Trees Pipes Tab Page.