Skip to main content

System Graph

When this button is selected, a screen appears where, via a series of radio buttons,

  • a graph of each Input Point can be displayed
  • a graph of each Booster Pump can be displayed
  • a graph of the total system pressure versus flow is displayed

The items on the Tool bar are:

imageebx_5174786.gifCopies the graph to the clipboard to enable pasting to another document.

imageebx_780282784.gif Saves the graph as a bitmap.

imageebx_-402274554.gif  Help on this screen

V lines -  inserts vertical lines on the chart

H lines - inserts horizontal lines on the graph

Page Margin - This increases or decreases the margin around the graph

Three Radio buttons to display:

Input Points – radio button for selection of the input points in the current project with a pull down selection list of the node number for each Input point. When the selected Input Point Flow/Pressures is being calculated, the entered Input Point curve is also plotted, unless the entered input point pressure is Fixed and is greater than 20 % above the calculated value and there is no loss coefficient for a tank exit. If it is not displayed it is assumed that it is a guess pressure.

Booster Pumps  – radio button for selection of the Booster Pumps in the current project with a pull down selection list of the pipe number of each Booster Pump. When the selected Booster Pump Flow/Pressure is being calculated, only the calculated flow and pressure point is plotted together with the User entered Margin.

Total  – radio button to display the pressure at the input point plus the pressure of all entered Booster pump(s), The Total is only available for a job with a single Input point and if all the booster pumps have the same flow as the Input Point.

The booster pumps are also displayed:

• as a curve unless the Input Point pressure is being calculated in which case only the operating point(s) are displayed.

• as a point if the flow and pressure of the particular booster pump is being calculated.  In this case the Total pressure curve with  the entered booster pump rather than the calculated  pressure can also optionally be displayed.

On the Total graph the system pressure versus flow curve is also displayed in red.

Display Entered Curve – This displays on the graph the entered Input Point curve if the Input Flow/Pressure is being calculated If it is not being calculated then the booster pump curves are added to the Input Point Curve.

Two Radio buttons to select the x axis of the graph being displayed as linear flow or flow to the power 1.85

Selecting Apply with Print Selection also selected, inserts the selected graph in the results.  Cancel returns to the Viewing and Printing results screen without inserting the graph.