Skip to main content

Booster Pumps & B.F.Preventers

On this screen, Booster Pumps and/or Back Flow Preventers may be entered. Booster Pumps and Back Flow Preventers are entered "in a pipe". A Back Flow Preventer is a double check detector assembly, or a reduced pressure detector assembly.

For Booster pumps and Back Flow Preventers, water is always assumed to flow from node A to node B (as entered on the Pipes Tab Page). This is very important as it is the one time that the order of the nodes is relevant and if entered incorrectly, wildly erroneous results can be produced.

The buttons on the Tool Bar for this page are:

imageebx_482209733.gif Close - exits this screen.

imageebx_463499438.gif Show Errors

imageebx_668880439.gif Deletes the current line (booster pump or back flow preventer).

imageebx_-402274554.gif Help on the current tab page.

Booster Pumps

The items of input for booster pumps are:

Pipe Number

Pump - a selection for Booster Pump

Curve/Linear

Flow 1, Pressure 1, Flow 2, Pressure 2,........Flow n, Pressure n

Back Flow Preventers

The items of input for back flow preventers are:

Pipe Number

B.F.Prev – a selection for Back Flow Preventer

Linear

Flow 1, Pressure 1, Flow 2, Pressure 2,..................Flow n, Pressure n

Once sufficient points are entered a graph appears in the lower portion of the screen displaying the points and the fitted curve. This is a useful check on the entered values and in the case of "curve" whether the curve fit is reasonable. At the right end of the graph, there is provision for extending the curve to check, in the case of curve, that the curve behaves acceptably past the last point on the graph.